1. Litter-Robot 4: Red light bar with partial white flashing (Globe position)
If your unit displays a red light bar with partial white flashing, this indicates that the unit did not detect the globe position during its previous cycle. You ...
Visit for solutions if your Litter-Robot 4 has a red light bar with a partial white flashing globe. Get instant support and fixes today.
2. Litter-Robot 3: All three lights flashing (Globe position fault)
Check and clear any obstructions in the waste port. Waste clumps or toys could obstruct the globe rotation and cause a globe position or over-torque fault.
Find solutions for your Litter-Robot 3's three lights flashing position sensors issue. Fix issues with your Connect Upgrade Kit today!
3. Litter Robot III - Home positioning fault - RobotShop Community
22 apr 2024 · 1- If you are using a generic power adapter causing the motor to fail during the cycle or cycle slower than the usual. 2- If the magnets of the ...
Recently our Litter Robot III LR3C-1200-CE (SN LR3CI359573) shows a home position fault. The globe stops at the end of the cycle just before it returns to its home position. Suggestions I found on the web didn’t help. It is using the official adapter and it is directly plugged in the wall socket. Up till now I just turn off the robot, reposition the globe by hand and turn it on again. It will cycle and will work for a while as expected until it doesn’t. Rinse and repeat. I don’t think the motor ...
4. Litter Robot 3 Home Position Fault - RobotShop Community
10 feb 2021 · The Hall Effect Sensor is the sensor responsible for the tracking of the globe's position. It's what makes your Litter-Robot so intelligent.
Hi! We got a Litter Robot 3 about 6 months ago. Yesterday it showed a Home Position Fault (all lights blinking sequentially from red to blue). I can’t seem to find anything online that deals with this precise issue. Would anyone have any suggestion? Thank you so much in advance for your help!
5. Litter-Robot 4: Red with partial yellow flashing (Over-torque fault)
Preparation · Check that your unit is not overfilled with litter. · If you recently added litter, the globe could have slowed down enough to trigger this fault.
Get solutions for your Litter-Robot 4 red with partial yellow flashing over-torque fault. Find easy fixes here! Explore our support page now.
6. Litter Robot III - Flashing lights sequentially or flashing all at once
If the lights on the control panel blink, right to left, left to right or together, the problem is still the same: the robot has failed to track the position of ...
Most of you are here because there are 3 flashing lights on your Litter-Robot's control panel. Sometimes this problem is caused by a faulty power supply or the motor itself. If even after checking the set screw on the motor and checking the voltage on the power supply with a multimeter, the lights…
7. Litter-Robot 3: Fixing the globe magnets
Litter-Robot 3 uses two magnets located in the globe gear track to monitor the position of the globe. ... globe and flip the magnet that is at the 1 o'clock ...
Troubleshooting your disassembled Litter-Robot 3 Globe? Our guide helps you check magnet positions and correct errors for a smoothly functioning unit.
8. Litter-Robot 4 Support, Troubleshooting, and Solutions
Our self-service troubleshooters are the fastest way to solve issues with your robot. Troubleshooter. Videos. Getting Started. Manuals. Installation Guides.
Need assistance with your Litter-Robot 4? Find guides & troubleshooting tips. Get the support you need today.